For a long time now I’ve been meaning to migrate my home file storage over to a ZFS server but the project kept getting postponed due to other priorities. Finally it’s alive!
For the last ten years or so my home fileserver has been through the general purpose debian box in the garage. It has three disks, one for the system and home directories, a larger one which gets exported over NFS and the largest one which backs up the other two (nightly rsync). It has been an adequate solution, in as far as I’ve never lost data. But whenever a disk dies I always have several days of downtime and have to scramble to restore from backups and maybe reinstall.
There are many articles about this topic that make for good reading if you’re considering the same. My goals were:
1. Data reliability, above all.
Initially I had visions of maximizing space, mainly for the geek value of having many terabytes of home storage. But in the end, I don’t really need that much. The NFS export drive on my debian box was currently only 500GB and that was use d not only by the shared data (pictures, mostly, and documents) but also for MythTV storage. Since I wasn’t planning on moving the MythTV data to the ZFS pool, even 500GB would be plenty adequate for some time.
2. Low power consumption.
Since this is another server that’ll need to run 24/7, I wanted to keep an eye on the power it uses.
3. But useful for general computing.
Since this will be the only permanent (24/7) OpenSolaris box on my home network, I also wanted to be able to use it for general purpose development work and testing whenever needed. So despite the goal of low power consumption, I didn’t want to go all out with the lowest possible power setup, needed a compromise.
Here’s the final setup:
CPU: AMD Phenom II X4 (quad core) 925. Reasonable power consumption and the quad cores give me something fun to play with.
Memory: 8GB ECC memory. Since I’m going primarily for data reliability, might as well go with ECC.
ZFS pool: 3 x 1TB drives. These are in a mirror setup, so total storage is just 1TB. That’s still about three times as much as I really need right now. With three drives, even if two fail before I get to replace them I should be ok. Igot each of the three drives from a different manufacturer, hopefully that’ll make them fail at different times.
NAME STATE READ WRITE CKSUM represa ONLINE 0 0 0 mirror ONLINE 0 0 0 c8d0 ONLINE 0 0 0 c8d1 ONLINE 0 0 0 c9d0 ONLINE 0 0 0
System disk: I expected to just use one older drive I had on the shelf, but after installing it I found it was running hot. Maybe it is ok but decided to do a two-way mirror of the rpool as well, maybe it’ll save me some time down the road. I don’t need much space here so found the cheapest drive I could get ($40) to add to the rpool. At that price, might as well mirror!
NAME STATE READ WRITE CKSUM rpool ONLINE 0 0 0 mirror ONLINE 0 0 0 c9d1s0 ONLINE 0 0 0 c10d1s0 ONLINE 0 0 0
Total power consumption for the box hovers around 78-80W most of the time.